Whilst I have a deep loathing for voodoo electronics one
conclusion I have arrived at is that tag-board construction will produce a
different tone from the same design based on a PCB, and I believe that tag-board can prove
best. So how did I arrive at this conclusion?
I built a tag-board (not a turret board) based amp a
while back with a fault. It was missing a wire that connected the preamp signal
to the power output stage. So the amp was dead, right? Well no, it carried a
very trebley signal at a low level to the speaker just because the components
on the tag-board are forced to be so close together. This isn’t voodoo its called
crosstalk and is well understood. I found the fault and the amp sprang to life. So it has a
feed-forward path and a bit of treble gets added from somewhere to somewhere
else, well so what.
Well try an experiment,
find a HiFi loudspeaker that has a Bi-wire option and play something familiar.
Now disconnect the tweeter and have a listen, half the sound disappears and
what is left is muddy and pretty torrid.
Lastly disconnect the woofer and connect just the tweeter. It’s all treble as expected but the volume
level compared with the woofer is fractional. Conclusion:- A small amount of treble
carries the weight of the sound. Now back to the tag board where co-located components
will cross-talk and bleed treble forward in the amp. I loaned the amp to a
friend to check it out at volume, he concluded that it had an “air” …. and I
think I know where it comes from.
